-
Is a CPU necessary to check I/O? Input signals to the input terminals of an input module are turned ON, however, the input status LED remains OFF.
Yes, a CPU is necessary. In the case of a system with no CPU, the input status LED does not work even if signals are externally input into the input module.
Show Detail
-
I use the high-speed counter module (Type_ NP1F-HC□). The user's manual (FEH210) shows 'Multiplication function_ x1, x4.' How can I switch between ...
The multiplication of the high-speed counter module is automatically set as follows depending on the input pulse form_
・ Forward pulse + Reverse pulse_ x1
...
Show Detail
- No:1564
- Displayed Date:2023/04/25 19:00
- Category:
Function
-
I use an Ethernet module (Type_ NP1L-ET□) in a redundant system. Is processing such as reopening of the Ethernet required at the time of redundancy...
The SPH system automatically inherits information such as the communication ports and reopening processing is not required.
Show Detail
-
I use an Ethernet module (Type_ NP1L-ET1/ET2) to read/write data from/to a PC in the loader command communication mode. At what time are data read ...
(1) Standard CPU_ Access takes place when tasks end (synchronized with tasks).
(2) High-performance CPU_ Access takes place when a request is generated rega...
Show Detail
-
With D300win, when I paste user FBs together with the POU from another project, a compilation error occurs. Why?
A compilation error occurs if the properties of the POU do not match. Specify the CPU type as 'Common.'
Show Detail
-
On the high-speed output module (Type_ NP1Y32T09P1-A), the ONL/ERR lamps are illuminated. Why does this happen?
Possible causes include a fuse blowout in the high-speed output module (Type_ NP1Y32T09P1-A).
Show Detail
- No:1342
- Displayed Date:2023/04/25 19:00
- Category:
Function
-
With the multi-channel high-speed counter module (Type_ NP1F-HC8), how can a single-phase pulse be received?
Pulse input type_ A-phase for the pulse and B-phase for the sign.
Show Detail
- No:1366
- Displayed Date:2023/04/25 19:00
- Category:
Function
-
I understand that when data are received via an Ethernet network in the TCP/IP unpassive mode, requests from multiple nodes can be accepted. How ca...
Input an arbitrary address. This setting is ignored for the unpassive mode.
Show Detail
-
What will happen to the station number assigned to each slot of a base board with a station number setting switch (Type_ NP1BS-**S, NP1BP-13S, NP1B...
The SX bus station number for the slot on which the CPU module is mounted is recognized as unused.
Show Detail
- No:1382
- Displayed Date:2023/04/25 19:00
- Category:
Main unit
-
Is it possible to use the SX control utility of D300win to back up a program written by using the Standard Loader (Type_ NP4H-SWN)?
Yes, it is possible.
Show Detail