1-9 of Total 9
This error occurs if data is received and the receive buffer is attempted to be overwritten while data in the receive buffer is being read to the memory in ... Show Detail
Possible causes are as follows: 1) The baud rate differs between the PLC and the target device. 2) The stop bit differs between the PLC and the target devi... Show Detail
There is a difference between 'Unpassive' and 'Fullpasisve' as follows. 1) Unpassive: Communicates with a device that has any IP or port No. 2) Fullpassi... Show Detail
What cable should I use for T-link?
Use the following communication cables from Furukawa Electric Co., Ltd. ・KPEV-SB 0.75mm2 x 1 pair (Max. length: 700m) ・T-KPEV-SB 1.25mm2 x 1 pair (Max. le... Show Detail
No, Fuji Electric general-purpose PLCs including the MICREX-SX series do not obtain it. Show Detail
POU control data is different between the two data transfer methods: 1) by using the MOVE instruction and 2) by connecting variables with a line. Therefor... Show Detail
Do addresses of T-link devices (slave stations) connected to T-link need to be consecutive?
No, they do not need to be consecutive. If there are a lot of unused addresses, it may be better to assign addresses at some intervals for the future expa... Show Detail
Instead of FNC120A-C10, can I use FNC130A-C10?
Yes, you can use FNC130A-C10 in combination with FNC120A-C10. Attach the same type of optical adapters at the both ends of the optical fiber. FNC130A has t... Show Detail
Is there a limit on the wiring length of P-link/PE-link cables?
Yes, both P-link and PE-link cables have limits on the wiring length. [P-link] ・Electrical transmission line Total length of electrical transmission ... Show Detail
1-9 of Total 9