The loader connector of SPH series CPU modules has been changed into RJ45 connector. Can I use an RS-232C/422 converter for personal computer loade...

No, you cannot use NW0H-CNV. The RS-232C/422 converter for personal computer loaders (Type_NW0H-CNV) needs to be supplied power from the PLC side, however, t... Show Detail

I attempted to clear the memory in a CPU with the 'Clear' command for online operations, however, I got a message saying 'Clearing failed' and coul...

There is a possibility of mismatch between the project in the user ROM card and the CPU memory. On the 'Failure diagnosis' dialog, check the 'Resource inform... Show Detail

I have connected the SX series CPU and the loader PC via USB. I have installed the USB driver and configured the communication settings, but commun...

There are two ways to connect a USB port of a personal computer and a CPU: 1) Connect to the USB port of the CPU (directly connected to the USB cable). 2) ... Show Detail

When I try to register a remote I/O master module using the I/O extension function in a multi-CPU configuration in the system definition, an error ...

No, you cannot use the I/O extension function in a multi-CPU configuration. Register a remote I/O master module in the normal mode or extension mode in a... Show Detail

Can I use a commercially available LAN cable as a loader cable that is used with the converter (Type_NP4H-CVU) to connect a personal computer loade...

No, you cannot. Use the dedicated loader cable (Type_NW0H-CA3). Show Detail

Can I upload a definition file downloaded from a configurator to NP1L-PD1/PD2?

No, you cannot upload a definition file. So, it is very important to keep backup of Definition file on PC side. Show Detail

When I use the SX communication middleware (Type_ NP4N-MDLW) and specify (_) in the access path during the item registration for the client, Errno=...

Move to the item ID without using the access path on the client side (D_). Show Detail

I cannot download a project to the user ROM card inserted in the CPU. What is a possible cause?

This problem is probably caused by the following reasons: [For SPH300/2000/3000 series] 1) The CPU mode selection switch is not set at the 'UROM-TERM' pos... Show Detail

Please tell me how to register a T-link model of UG (or V Series) as a POD in the system definition.

Select a T-link capsule and set the numbers of input/output words. By default, a POD requires one word for input and one word for output. Show Detail

Is communication possible with the UI4 type not supported based on the manual description of the SX communication middleware (Type_ NP4N-MDLW)?

UI4 is not supported by the specification with the VB automation interface. Meanwhile, UI4 is supported by the custom interface specification. Show Detail