In the diagnostic screen, error message 'Fatal failure SX bus error Time up error of deciding SBM use mode' appeared. What are the possible cause...

Check that the terminating plug is attached. Check also that the SX bus expansion cable is not broken. You need to attach an SX bus terminating plug at bot... Show Detail

When I started a MICREX-SX series PLC after downloading a program into it, a fatal fault occurred. The loader software says 'system construction er...

This error occurs when the system configuration set by the loader software differs from the actual configuration. For example, a defined module is not mount... Show Detail

When I change a program online (patch POU), error message shown 'The resevation area of the non-retain memory of POU xxx is short (2 word).' Why?

Once a compilation error occurs during patch POU, the project must be compiled and downloaded again. Therefore, you need to stop the CPU. Please consider the... Show Detail

I want to edit the program of the PLC (SX series). In the catalogue and website, I found that two types of program loaders, Standard and Expert (D3...

Both Standard and Expert (D300win) are program loader software for the SX series. However, there is no compatibility between program data (called 'project')... Show Detail

I creat user FB in StandardV3, and defined input/output parameter as word (WV). Can I directly access any bit within this parameter WV?

No, you cannot access the input (output) parameter (WV*, DV*) for which the data length is set in words/ double-words by using a bit address within the user ... Show Detail

We share the D300win and other PLC engineering tool software among several people. Do we need to purchase the software for each person?

Fuji Electric offers a multiple-license (multi-license) agreement. You need to purchase licenses for all PCs on which the software will be installed and use... Show Detail

The MICREX-F series T-link has the fail-soft function. Does the MICREX-SX series T-link have the same function?

The MICREX-SX series T-link also has the fail-soft operation function, but not the general fail-soft function. In MICREX-SX, fail-soft operation can be ind... Show Detail

Where is the USB driver of USB/RS-422 converter for personal computer loader (Type_NP4H-CVU)?

The USB driver of USB/RS-422 converter for personal computer loader is stored in the 'UsbToSerial' folder in the 'Driver' folder in the folder where the pers... Show Detail

I use the CPU module of Type NP1PS-32R/74R/117R/245R. When I create a new project, the displayed option is 'PS32/PS74/PS117/PS245' only. Which shou...

Select 'PS32/PS74/PS117/PS245.' With the D300win, 'NP1PS-32/74/117' and 'NP1PS-32R/74R/117R' indicate the same model selection. This applies to all CPUs ... Show Detail

I converted a MICREX-F program to a MICREX-SX using StandardV3 loader. Contact and coil M8720 (TEMP0) which did not exist before conversion were cr...

The execution order of the contacts and coils in a ladder circuit partly differs between MICREX-F and MICREX-SX. Therefore, if a MICREX-F program is convert... Show Detail