Can I connect a MICREX-SX series T-link interface module (Type_NP1L-RT1) to a MICREX-F series T-link master module?

Only when the MICREX-F CPU is F55/F70/F70S/F80H/F120H/F120S to F150S, you can connect a MICREX-SX series T-link interface module although the order of the bi... Show Detail

Are there any I/O modules that cannot be mounted on the T-link expansion base?

You cannot mount the following I/O modules_ 　(1) High-speed input module NP1X3206-A, (2) High-speed output module NP1Y32T09P1-A, (3) Analog input module NP... Show Detail

I have connected the SPH Series with the POD (UG Series) via the T-link. A code F8 is displayed on the screen of the POD. What is a possible cause?

This problem was probably caused by the following factors_ (1) Failed contact of the connector on the SPH, (2) Failed contact on the POD (UG), (3) Improp... Show Detail

I want to expand the T-link expansion (T-link interface module Type_ NP1L-RT1) by further adding a base. Can I do this expansion by using the SX bus?

T-link or other expansion bases cannot be added by the SX bus. Show Detail

I attempted to register 10 units of thermocouple input module (Type_ NP1AXH4-TC) on the T-link expansion (Type_ NP1L-RT1) base but it was not possi...

There is a limit to the number of words for the I/O modules that can be mounted on a T-link expansion (Type_ NP1L-RT1) base_ 128. With the thermocouple inpu... Show Detail

I find the TER_LED of the T-link master module (Type_ NP1L-TL1) sometimes illuminated. The communication speed is lowered when it occurs.

It may be caused by noise. Check the surrounding environment and wiring routes for any problem. The lowered communication speed is assumed to be because t... Show Detail