With a positioning control module (Type_ NP1F-MP2/MA2), what are the statuses of the status information signals after power-up?

The near zero signal/command pulse zero signal/positioning end signal/RDY signal of the status information signals are set to [1]. The interrupt input sig... Show Detail

With the pulse train output positioning control module (Type_ NP1F-HP2), positioning has ended but the end signal is not generated.

If the start bit remains on, the positioning end signal is not generated. Show Detail

Regarding description in the ST language, is it possible to write an expression such as 'variable name + 1' in the brackets of an array?

A description in the brackets of an array must only include values or variable names. Writing an expression in brackets is not possible. Show Detail

On the positioning module (Type_NP1F-MP2/MA2), the 'ERR' LED turns ON. What are the possible causes?

A possible cause is that a “Deviation amount over error” occurred. For details, refer to the user's manual FEH213 (NP1F-MA2) or FEH214 (NP1F-MP2) 'Section 8 ... Show Detail

Does the built-in ALM contact of the power supply module of SPH maintain its status (contact closed) even if the power supply recovers to normal af...

When the power supply recovers to normal, the ALM contact automatically returns to the original position (open). Show Detail

Which is the signal that indicates pulse output completion on the positioning control module (Type_ NP1F-MP2)?

Pulse output completion is indicated by the 'Command pulse zero' signal. Normally, it is '1' to indicate the status of completion. When the number of pulses... Show Detail

How long is the refresh cycle of the pulse count value data of the high-speed counter module (Type_ NP1F-HC2)?

The NP1F-HC2 constantly continues updating the pulse count value data for the SX bus I/F in a cycle of 200 ?s (fixed). The count data, however, will be refle... Show Detail

In the standard expansion counter FB _MHCNTH, CH0 operates but CH1 does not.

It seems that this problem was caused by an improper address setting for INDAT/OUTDAT assigned to the counter FB terminal. On a single module, assign the sa... Show Detail

When I enter the global timer T8192 in the Standard loader, an error message appears saying 'This address is beyond the available range.' What is t...

The error occurs because the address display mode is set to 'FLEX-PC,' but the address representation of the word device is not hexadecimal. For the addres... Show Detail

I am using the StandardV3 loader. Can I check the download history to the CPU?

When all the programs are downloaded into the CPU, the download history is not stored. However, when only a changed program is downloaded (online program c... Show Detail