No, the expansion cable supplied with the expansion unit is only available. Show Detail
You can use the following program as an alternative. When you turn on the differential command 'M0,' the differential output 'M2' turns ON for one scan. ... Show Detail
Do addresses of T-link devices (slave stations) connected to T-link need to be consecutive?
No, they do not need to be consecutive. If there are a lot of unused addresses, it may be better to assign addresses at some intervals for the future expa... Show Detail
Where is the USB driver of USB/RS-422 converter for personal computer loader (Type_NP4H-CVU)?
The USB driver of USB/RS-422 converter for personal computer loader is stored in the 'UsbToSerial' folder in the 'Driver' folder in the folder where the pers... Show Detail
In the parameter setting of the Ethernet module in the system definition, set the 'Server FTP command watch timer value' to 0. The port is not closed even if... Show Detail
Both the pulse output and control output are open collector outputs. They should be used within the following ranges (1) Pulse output_ 30 V DC, 40 mA or less... Show Detail
I use the Ethernet module (Type_NP1L-ET1). Is the IP address assigned automatically?
The IP address is not assigned automatically. (DHCP function is not supported.) The default IP address is '192.168.0.1'. You can check the IP address b... Show Detail
It depends on the specifications and combinations of Ethernet devices. Communication ports of Ethernet devices have either of the following specifications. ... Show Detail
One M_OPEN consumes one port of SPORT_NO, which is the local port. RPORT_NO is the port of the other end of the communication seen from the SX. Show Detail
This is because the SX bus loop-back plug is not connected. Connect a loop-back plug to the base board. Show Detail
51-60 of Total 398