For the Standard loader V2, you cannot specify array data for the operand that specifies the first address. (An error is detected during the program check.) ... Show Detail
A nonfatal fault of the takt cycle monitoring error has occurred. What is a possible cause?
The takt cycle monitoring error is caused by the following factors_ (1) The preset takt cycle value specified in the system definition is shorter than the ac... Show Detail
Newly purchased SPF shows Battery error. How can I solve it ?
Since the primary battery built in the SPF main unit cannot be replaced, the battery connection switch is set to off at the factory shipment. By turning on t... Show Detail
Yes, it is the same as in the SPH series (except for SPH3000MM). Show Detail
Yes, it is the same as in the SPH series (except for SPH3000MM). Show Detail
What are <N-mode> and <SX mode> in the SPB series?
The SPB firmware has two operation modes: “N-mode” and “SX-mode.” Applicable personal computer loader varies depending on the firmware used. <N-mode&g... Show Detail
You can use the following program as an alternative. When you turn on the differential command 'M0,' the differential output 'M2' turns ON for one scan. ... Show Detail
I bought a USB 3.0 cable (A-B type) to connect to FLT-ASFKA. However, I cannot connect them.
FLT-ASFKA is equipped with a USB2.0 (B type) connector. The connecter shape is different between USB 3.0 (B type) and a USB 2.0 (B type). Purchase a USB 2.0 ... Show Detail
What is the replacement for FLEX-PC NB0 series?
MICREX-SX series SPF is the replacement for FLEX-PC NB0 series. Refer to the following user's manual. 'Replacement Manual NB0 to SPF [Hardware Selection... Show Detail
Instead of FNC120A-C10, can I use FNC130A-C10?
Yes, you can use FNC130A-C10 in combination with FNC120A-C10. Attach the same type of optical adapters at the both ends of the optical fiber. FNC130A has t... Show Detail
31-40 of Total 398