- GLOBAL > PLC > SPH > Communication (T-link) > I have connected the SPH Series with the POD (UG Series) via the T-link. A code F8 is displayed on the screen of the POD. What is a possible cause?
GLOBAL
I have connected the SPH Series with the POD (UG Series) via the T-link. A code F8 is displayed on the screen of the POD. What is a possible cause?
I have connected the SPH Series with the POD (UG Series) via the T-link. A code F8 is displayed on the screen of the POD. What is a possible cause?
- Category :
-
- GLOBAL > PLC > SPH > Communication (T-link)
Answer
This problem was probably caused by the following factors_
(1) Failed contact of the connector on the SPH,
(2) Failed contact on the POD (UG),
(3) Improper communication settings, or
(4) Duplicated T-link station numbers.