Pressing the reset switch does not clear history data.
<Causes> The switch is not pressed twice. The switch function is not set to [Reset]. The switch is disabled according to the interlock setting. ... Show Detail
The data displayed in a trend graph is different from the most recent data in the PLC.
<Cause> The trend graph is not redrawn. <Solution> The graph data once displayed is not updated unless the redraw command is specified. To ... Show Detail
Communication between the temperature controller and the V series is slow (V7 series).
To speed up communications, try the following method. The condition can also be improved as described below. <Baud rate> Increase the communicatio... Show Detail
The time and date is not displayed correctly.
The solutions vary depending on the screen data settings. Check the following settings. Setting location: V-SFT editor [System Setting]→[Unit Setting]→[... Show Detail
<V-Server> Is the number of the logging to register limited on V-Server?
It depends on the version of V-Server. Version Number of the logging to register Ver.2.0.0.3 or later No limitation Ver.1.0.0.0 - Ver.2.0.0.2 Up... Show Detail
<V-Server> Is the number of tags to be registered limited?
No. However, registering more tags will place a greater burden on V-Server and thus a polling time interval may become longer. Notes: It requires approx... Show Detail
How to paste the currently displayed screen image into another application like Microsoft Word
Four methods are available. Follow the steps below. [Method 1: Copy the screen image on the emulator to the clipboard] When the emulator screen is used, a ... Show Detail
"Insert Storage in TS" "Insert CF Card in xx" (xx:V8 or V7)
Though automatic program uploading upon power-on is enabled by screen configuration, no storage device(SD card, USB memory, CF card, etc.) is inserted in the... Show Detail
Is there a model without function switches?
Yes, there are special models available without function switches or logos imprinted on the bezel. [Model details] Special models are designated with a num... Show Detail
Cannot make entries with a keypad.
There is no entry target (no cursor is displayed). Entered valued is out of preset alarm lange. (the ENT key is not valid) The bit (Bit 15) for enabling/di... Show Detail
221-230 of Total 315