Check the [Waiting time for structure check] and [Fail-soft operation setting] settings on the SX side. If the [Waiting time for structure check] setting is... Show Detail
I cannot set the IP address to setup VPN connection.
Check the settings below: V10/V9's calendar settings If date and time set on the V10/V9 unit is not correct, it is not possible to establish VPN connecti... Show Detail
How to check the communication condition between the temperature controller and the V/TS
The temperature controller condition is output to the system device memory of the V/TS. Check the following addresses for each station number. [V8/TS] Sel... Show Detail
<V-Server> What are the V-Server startup options?
By adding these options whenlaunching theV-Server, the corresponding operations such as automatic termination or log saving become available. Options Opt... Show Detail
How to connect to a temperature controller / inverter without connecting to a PLC
The method differs according to the TS/the V series model. TS/V8 series Select [System Setting]→[Hardware Setting]→[PLC1] on the V-SFT editor and configure... Show Detail
"The font file cannot be found."
This error is displayed when Gothic fonts used in the screen data are not installed. <Solutions> Update the V-SFT editor to version 5 from our webs... Show Detail
Can I reflect the settings in a screen program to change the local screen settings?
There are two methods. Method1: Using [Clear Ini File] option when downloading the screen program from the configuration software (PC). Method2:Operating t... Show Detail
How to make a switch work only when the switch is held down
Follow the steps below. Display the [Switch] dialog. From [Other Settings], click [Delay] and configure [ON delay] (units: 100 msec). Example: The preset o... Show Detail
How to change the setting for buzzer sound when a swich is pressed.
There are three methods. [Change the setting on V series] Change setting in Local mode > [System setting] > [Buzzer setting], and press [Apply] swi... Show Detail
The V series does not switch from the RUN screen to Local mode.
Click here for the method for switching to Local mode. [If the switch menu is not displayed when the [SYSTEM] switch is pressed] <Cause> Advanced ... Show Detail
161-170 of Total 315