Can I add transition effects to my screens or pop-up windows when they appear?
Using transition function of the switch provides 15* transition effects. *4 transition effects for overlap windows. E.g.: Slide-in *Transition ... Show Detail
The V10/V9 series backlight cannot be replaced by customers. Consider returning the unit for repairs. For information on repairs and a test unit during its... Show Detail
I want to create a flow chart screen but it is too large to fit in single screen.
Images can be laid out four times the screen size in height or width. The whole are of a large image can be confirmed easily by scrolling the screen. As you... Show Detail
I want to connect a camera and display video on MONITOUCH
Video cameras *, network cameras, and USB cameras are supported. * V10: By attaching an optional unit "GUX-xx" onto G-type V10 series, video input is avail... Show Detail
How to change communication setting such as [Signal Level] and [Baud Rate]
There are two methods. [Change the setting on V series] Change setting in Local mode > [Comm. setting] and press [Apply] switch. To restore the scr... Show Detail
I want to disconnect my VNC client from the V10/V9.
You can disconnect the VNC client by one of two methods: Call the status bar on the bottom right corner of the screen. ■ For Advanced models: Pressany tw... Show Detail
How to use a storage device with minimal concern for its life or other limitations
The number of the storage device write times can be reduced as described below. [TS/V8] Increase the number of sampling times from the primary storage targ... Show Detail
How to set (correct) the calendar
The correction method differs depending on the calendar reading target (PLC or V/TS). For the reading target, check the following setting. Setting locati... Show Detail
Graphics do not move on an animated screen (in graphic or graphic relay mode).
The causes and solutions are explained for cases where the following parts are used. TS/V8 Graphic V7 Series Graphic Relay Graphic <Causes> Pa... Show Detail
Transparency of a pattern is not effective on an animated screen.
<Cause> The size of the pattern is greater than 4,088 dots. <Solution> The transparency setting is enabled for pattern sizes up to 4,088 dot... Show Detail
1-10 of Total 315