-
Products & Solutions TopProducts & Solutions
-
Products & Solutions Top
-
Drives & Controls
-
UPS & Industrial Power Supply
-
Sensors & Measurements
-
Energy Management
-
Monitoring & Control System
-
Distributions & Controls
-
Transmission & Distribution
-
Transit System
-
Semiconductors
-
Energy
-
Food and Beverage Distribution
-
Service & Equipment Upgrades
-
Solutions
-
-
IR TopInvestor Relations
- GLOBAL > PLC > SPH > Communication (Others) > Can I replace NP1L-FL2 with NP1L-FL3 for FL-net communication?
Can I replace NP1L-FL2 with NP1L-FL3 for FL-net communication?
Can I replace NP1L-FL2 with NP1L-FL3 for FL-net communication?
- Category :
-
- GLOBAL > PLC > SPH > Communication (Others)
Answer
When connected via 10BASE-T, you can replace it. There is no need to change the system definition. Before replacement, set the switches on the front of the NP1L-FL3 module such as the FL-net node No. selection switch according to those on NP1L-FL2. (NP1L-FL3 supports FL-net Ver.2 and has one port of 10BASE-T/100BASE-TX interface (10M/100Mbps auto-changeover). It is possible to use NP1L-FL3 with NP1L-FL2 in 10Mbps communication.)