The correction method differs depending on the calendar reading target (PLC or V10/V9 series).
For the reading target, check the following setting.

Setting location:
V-SFT editor [System Setting] [Unit Setting] [SRAM/Clock]
[Use SRAM Calendar]
Checked .... Clock built in the V series used
Unchecked .... Clock built in the PLC used

[Checked ..... Clock built in the V series used]

1. Press [Date/Time Setting] in the menu icons in Local mode to display the Date/Time Setting screen.
   
    
2. Configure the date and time and press the [Set] switch to confirm.
   
   

The date in the upper right corner of the screen is updated.

[Unchecked ..... Clock built in the PLC used]

1. Correct the PLC calendar device memory referring to the relevant PLC manual.
   
    
2. Set (0 -> 1) the device memory set at [System Setting] -> [Hardware Setting] -> [Control Area] ->[Calendar Read Device] with the V-SFT editor.
   

The V10/V9 series reads the PLC calendar data.

* To correct the calendar using a macro command click here.