-
Products & Solutions TopProducts & Solutions
-
Products & Solutions Top
-
Drives & Controls
-
UPS & Industrial Power Supply
-
Sensors & Measurements
-
Energy Management
-
Monitoring & Control System
-
Distributions & Controls
-
Transmission & Distribution
-
Transit System
-
Semiconductors
-
Energy
-
Food and Beverage Distribution
-
Service & Equipment Upgrades
-
Solutions
-
-
IR TopInvestor Relations
- GLOBAL > PLC > SPH > Communication (Ethernet) > The D300win cannot connect to the SX via the Ethernet module.
GLOBAL
The D300win cannot connect to the SX via the Ethernet module.
The D300win cannot connect to the SX via the Ethernet module.
- Category :
-
- GLOBAL > PLC > SPH > Communication (Ethernet)
Answer
The IP address of the Ethernet module will become effective when the power supply is turned off once and then
turned on again after the module driver is downloaded. Try turning the power supply off once and turning it on
again and check the operation. Moreover, set the communication parameter to add a space and 507 (when the Self
port standard No. is the default value of 256) after the IP address.
[Related document]
Refer to '4-3-3 Communication settings 3) When communication board is used' in the user's manual 'SX-Programmer Expert (D300win) [Reference]' (FEH257).
[Related document]
Refer to '4-3-3 Communication settings 3) When communication board is used' in the user's manual 'SX-Programmer Expert (D300win) [Reference]' (FEH257).